Connect the other end of the PowerLink cable to the host. Connect the external power supply to the power jack on the PowerLink Cable. Connect the MVC cable to the pin. Before continuing verify that the MVC cable is connected to the proper communication jack on the scanner. Incorrect cable connection can cause communication problems or potential damage to the scanner. A software driver and correct configuration setting are also required for proper communication to occur.
The Aux jack has a square opening. Connect the external power supplies for the auxiliary scanner and the MS to the power jacks on the two PowerLink cables. Before continuing verify that the PowerLink cables are connected to the appropriate interface jacks on the scanner. Check the AC input requirements of both power supplies to make sure the voltage matches the AC outlets. Connect AC power to the transformers. The outlets should be near the equipment and easily accessible.
Configure the MS for the appropriate interface configuration settings. Scan the following bar code to configure the auxiliary port on the MS to accept a Metrologic scanner as the secondary scanner. The following bar codes do not apply when using an MS as a secondary scanner. Contact a Metrologic representative for additional information on the MS If the glass window requires cleaning, use only a mild glass cleaner containing no ammonia.
When cleaning the window, spray the cleaner onto a lint free, nonabrasive cleaning cloth then gently wipe the window clean. If the red window requires cleaning use mild soap and water with a lint free, non-abrasive cleaning cloth then gently wipe the window clean. The MS has 2 labels on the back of the unit.
These labels contain the model number, date of manufacture, serial number, and caution information. An additional caution label is located under the window faceplate and a label noting the jack interfaces is located under the connector cover. The following are examples of these labels.
To maintain compliance with standard CSA C Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password? Enter your email address and check your inbox. The MS Series scanners have a three 3 year or two 2 year limited warranty from the date of manufacture.
The duration of the warranty is dependent upon the country where the product was purchased. Operation is subject to the following two conditions: 1 This device may not cause harmful interference, and 2 this device must accept any interference received, including interference that may cause undesired operation.
Page 54 Never attempt to look at the laser beam, even if the scanner appears to be nonfunctional. Never open the scanner in an attempt to look into the device. Doing so could result in hazardous laser light exposure. Patents: U. Patent No. Print page 1 Print document 60 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Sign up!
Restore password. Upload manual. Labels: Metrologic. Newer Post Older Post Home. Subscribe to: Post Comments Atom. Search This Blog. Search the web. Note: Your bar code scanner has been programmed with default settings at the factory and. Previous Page. Next Page. Msi series laser bar code projection scanner 57 pages.
Summary of Contents for Metrologic MS Page 1 Note: Your bar code scanner has been programmed with default settings at the factory and should be ready to be configured. Page 3: Important Safety Information Fuels and their vapors will become explosive if ignited. Spilled or leaking fuels cause vapors.
0コメント